3 AXIS SIDE CLAMP

• Side-to-side positioning of the Clamp Screw is done by moving the Slide Block sideways on the Slide Bracket and securing it when the desired location is reached.
• Up-and-down positioning of the Clamp Screw is done by moving the Slide Bracket vertically until the desired position is reached and then securing it in place.
• Fore-aft positioning of the 3 Axis Side Clamp in small increments is possible with the closely-spaced clearance hole pattern on the base. The length of movement in the Clamp Screw overlaps these increments, allowing unlimited range of clamping action.
• Material: Hardened alloy steel and ductile iron.

PIVOTING SIDE CLAMP

• The action of this clamp directs a powerful clamping force forward and slightly downward.
• The workpiece is held securely and prevented from lifting away from its locators. Either serrated grippers (P/N 10452), or smooth toggle pads (P/N 10453) can be placed in any of the tapped holes in the nose of the clamp.
• The 6 degree ramp angle on hold down slots prevents the clamp from backing away from the work. Cap screws shoulder squarely on special washer plates which are captured in the slots.
• The clamp is positioned close to the workpiece using cap screws into tapped holes. The clamp is quickly activated and released using an allen wrench.

SIDE CLAMPS

• Tooling Washers, Round Rest Pads  or Shims may be used to increase height of Side Clamps.
• Material: Hardened alloy steel.

TOE CLAMPS

• Powerful, low profile clamps that grip on the side of the work leaving the top surface open.

• A special washer, to prevent damage by the cap screw is included with each clamp.

MITEE-BITE CLAMP